where to put this grey "sticker" in my Toon?

Forum about Toon hardware, both versions 1 and 2 of Toon

Moderators: marcelr, TheHogNL, Toonz

Post Reply
bartch
Starting Member
Starting Member
Posts: 13
Joined: Sat Mar 03, 2018 12:00 pm

where to put this grey "sticker" in my Toon?

Post by bartch »

Hi,
while opening my Toon, a little grey square sticker fell out. (1mm thick)
Does somebody know where it belongs? Does it have to protect or isolate something?
thanks!
Bart
marcelr
Global Moderator
Global Moderator
Posts: 1153
Joined: Thu May 10, 2012 10:58 pm
Location: Ehv

Re: where to put this grey "sticker" in my Toon?

Post by marcelr »

I think it's on top of the temperature sensor. The back of toon (grey part) has a neat square slot where it should go. Just put it in there before you close your toon.
bartch
Starting Member
Starting Member
Posts: 13
Joined: Sat Mar 03, 2018 12:00 pm

Re: where to put this grey "sticker" in my Toon?

Post by bartch »

:) thanks! it has the same size!
FunFair
Starting Member
Starting Member
Posts: 42
Joined: Sun Oct 01, 2017 11:40 am

Re: where to put this grey "sticker" in my Toon?

Post by FunFair »

I wonder what the point is of putting a thermal pad there?
It doesn't really make good contact with the sensor chip and the chip is pretty much shielded by plastic. (i see no holes)
Smiggel
Member
Member
Posts: 57
Joined: Wed Apr 11, 2018 2:20 pm

Re: where to put this grey "sticker" in my Toon?

Post by Smiggel »

Guess I was not the only one with this issue. Here it fell out too. :-) Put it back now with the help of this thread. Thanks!
Fietspomp
Starting Member
Starting Member
Posts: 27
Joined: Tue Jan 30, 2018 12:09 pm

Re: where to put this grey "sticker" in my Toon?

Post by Fietspomp »

Hmm, I also saw it falling out but never figured out/bothered to place it back :D

But sometimes I wonder if the temperature sensor is correct, seems a little high, maybe this is the cause?
Anyway there's an offset I believe, to adjust the temperature.
Post Reply

Return to “Toon Hardware”