Remeha iSense and C-mix

This Forum is about the Opentherm gateway (OTGW) from Schelte

Moderator: hvxl

Post Reply
thomas_n
Starting Member
Starting Member
Posts: 5
Joined: Mon Aug 05, 2019 6:08 pm

Remeha iSense and C-mix

Post by thomas_n »

Hi everyone,


I have a Remeha boiler which also has a C-mix unit which enables it to control 2 zones. This module is controlled by an iSense thermostat.

Now the special thing about this setup is that the iSense thermostat controls both zones over a single OpenTherm line.

Is this supported in any way by the OpenTherm gateway? I have the module set up, but it is not connected to my computer (yet).


Thomas
hvxl
Senior Member
Senior Member
Posts: 1965
Joined: Sat Jun 05, 2010 11:59 am
Contact:

Re: Remeha iSense and C-mix

Post by hvxl »

I assume you are referring to the use of the message IDs for a second CH circuit (ID8, 23, 31, 37 and some bits in ID0). The OTGW has no commands to manipulate these. But it will report them and pass them on.
Schelte
Post Reply

Return to “Opentherm Gateway Forum”