Kit received, few questions

[jcw]

But on the bridge board we have digital 0 ... 13 and analog 0 ... 5.

Maybe this helps: http://jeelabs.org/2010/12/02/bridge-board-–-caveats/

[jeroenbs]

This is what I use in the header of the sketch (all pins, ports etc)

Code: Select all

                JeeNode / JeeNode USB / JeeSMD
     -------|-----------------------|----|-----------------------|----       
    |       |D3  A1 [Port2]  D5     |    |D3  A0 [port1]  D4     |    |
    |-------|IRQ AIO +3V GND DIO PWR|    |IRQ AIO +3V GND DIO PWR|    |
    | D1|TXD|-----------------------      -----------------------     |
    | A5|SCL|                                       D12|MISO|+3v |    |
    | A4|SDA|   Atmel Atmega 328                    D13|SCK |MOSI|D11 |
    |   |PWR|   JeeNode / JeeNode USB / JeeSMD         |RST |GND |    |
    |   |GND|                                       D8 |BO  |B1  |D9  |
    | D0|RXD|-----------------------      ------------------------    |
    |-------|PWR DIO GND +3V AIO IRQ|    |PWR DIO GND +3V AIO IRQ|    |
    |       |    D6 [Port3]  A2  D3 |    |    D7 [Port4]  A3  D3 |    |
     -------|-----------------------|----|-----------------------|----

regards Jeroen