The loop was still going in the serial console. Figured out it was a botched busybox installation.
In my lack of knowledge, I deleted busybox from the Toon to fix it.
and now linux wont boot anymore because it doesnt recognise any commands in the init.d
Managed to run toonrecovery from the Pi and get into the serial console. But it stops doing anything after this:
Code: Select all
IP-Config: Complete: device=eth0, addr=192.168.178.74, mask=255.255.255.0, gw=192.168.178.150, host=toon, domain=, nis-domain=(none), bootserver=192.168.178.150, rootserver=192.168.178.150, rootpath= Looking up port of RPC 100003/3 on 192.168.178.150 PHY: 1:10 - Link is Up - 100/Full ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready Looking up port of RPC 100005/3 on 192.168.178.150 VFS: Mounted root (nfs filesystem) on device 0:13. Freeing init memory: 116K