HI all,
I have the same error as @rybyan when i try to install Dropbear with firmware 4.9.23.
opkg install dropbear_2015.71-r0_qb2.ipk
Collected errors:
* pkg_run_script: package "dropbear" postinst script returned status 255.
* opkg_configure: dropbear.postinst returned 255.
this is what i have done before (manual Marcelr):
1) connect my serial interface to toon ->Works
2) enter the password for U-Boot 2010.09-R8 ->Works
3) command "printenv" -> Works
4) command "setenv addmisc setenv bootargs \$\{bootargs\} mem=\$\{mem\} lpj=999424 init=/bin/sh" -> Works
5) command "run boot_nand" ->Works
6) not edit "/etc/inittab", because getty not works with firmware 4.9.23. (manual marcelr)
7) edit "/etc/passwd" remove disabled to line "root::0:0:root:/root:/bin/sh" ->Works
no reboot toon/go to Dropbear installation with firmware 4.9.23
9) download package dropbear_2015.71-r0_qb2.ipk ->Done
10) package to ASCII with command "base64 dropbear_2015.71-r0_qb2.ipk > dropbear_2015.71-r0_qb2.ipk.b64" ->Done
11) then command "cat > dropbear_2015.71-r0_qb2.ipk.b64". After 15 minutes to wait no response from MInicom, but i can select <Ctrl+A> S en transfer the file to Toon.
When i connect with MInicom back to Toon <Ctrl+D> , i see the transfer file "dropbear_2015.71-r0_qb2.ipk.b64 " in the directory of Toon.
12) after command "base64 -d dropbear_2015.71-r0_qb2.ipk.b64 > dropbear_2015.71-r0_qb2.ipk", i see the file "dropbear_2015.71-r0_qb2.ipk"in the directory of Toon.
13) Now i try install the file with "opkg install dropbear_2015.71-r0_qb2.ipk" ,but now i see the error :
Collected errors:
* pkg_run_script: package "dropbear" postinst script returned status 255.
* opkg_configure: dropbear.postinst returned 255.
What i did wrong?