where to put this grey "sticker" in my Toon?

Forum about the tweaking of the Eneco Toon.

Moderator: marcelr

where to put this grey "sticker" in my Toon?

Postby bartch » Thu Mar 22, 2018 3:45 pm

Hi,
while opening my Toon, a little grey square sticker fell out. (1mm thick)
Does somebody know where it belongs? Does it have to protect or isolate something?
thanks!
Bart
bartch
Starting Member
Starting Member
 
Posts: 5
Joined: March 2018

Re: where to put this grey "sticker" in my Toon?

Postby marcelr » Thu Mar 22, 2018 6:40 pm

I think it's on top of the temperature sensor. The back of toon (grey part) has a neat square slot where it should go. Just put it in there before you close your toon.
marcelr
Advanced Member
Advanced Member
 
Posts: 824
Joined: May 2012
Location: Ehv

Re: where to put this grey "sticker" in my Toon?

Postby bartch » Thu Mar 22, 2018 7:25 pm

:) thanks! it has the same size!
bartch
Starting Member
Starting Member
 
Posts: 5
Joined: March 2018

Re: where to put this grey "sticker" in my Toon?

Postby FunFair » Mon Apr 02, 2018 8:09 pm

I wonder what the point is of putting a thermal pad there?
It doesn't really make good contact with the sensor chip and the chip is pretty much shielded by plastic. (i see no holes)
FunFair
Starting Member
Starting Member
 
Posts: 29
Joined: October 2017

Re: where to put this grey "sticker" in my Toon?

Postby Smiggel » Sun Apr 29, 2018 8:22 am

Guess I was not the only one with this issue. Here it fell out too. :-) Put it back now with the help of this thread. Thanks!
Smiggel
Starting Member
Starting Member
 
Posts: 20
Joined: April 2018


Return to Eneco Toon as Domotica controller

Who is online

Users browsing this forum: No registered users and 1 guest