remeha calenta not sending information

This Forum is about the Opentherm gateway (OTG) from Schelte

Moderator: hvxl

remeha calenta not sending information

Postby labium » Sun Jul 08, 2018 3:30 pm

i bought a nodo shop otg with wifi . it oconnects well to the otmonitor program. i connected my calenta remeha boiler to the gateway but no info shows up in the otmonitor program i have no thermostat connected yet. am i doing something wrong. the boiler is connected tot the boiler plug of the otg and in the boiler connected to the plug where normally the thermostat is in (on -off)
labium
Member
Member
 
Posts: 481
Joined: February 2010
Location: netherlands

Re: remeha calenta not sending information

Postby hvxl » Mon Jul 09, 2018 10:56 pm

Normally you should get some output from the OTGW. How did you configure the NodeMCU and OTmonitor? Is there a flashing LED on the OTGW? Do you get any response on a PR=A command?
Schelte
hvxl
Senior Member
Senior Member
 
Posts: 1084
Joined: June 2010

Re: remeha calenta not sending information

Postby labium » Wed Jul 11, 2018 6:25 pm

o do get respons from the otg but the otg doesnt get any response from the boiler
labium
Member
Member
 
Posts: 481
Joined: February 2010
Location: netherlands


Return to Opentherm Gateway Forum

Who is online

Users browsing this forum: No registered users and 1 guest