Toon's clock is 2 minutes behind

by **TheHogNL** » Thu Sep 06, 2018 2:37 pm

MyZ wrote:How do I restart chrony?

/etc/init.d/chronyd restart

by **MyZ** » Thu Sep 06, 2018 5:31 pm

Thnx. Did some restarts, but didn't had any effect. I'm getting these messages after rebooting:

Code: Select all: ep 6 17:58:44 eneco-001-209949 daemon.info chronyd[1299]: chronyd version 1.27 starting Sep 6 17:58:45 eneco-001-209949 daemon.info chronyd[1299]: Linux kernel major=2 minor=6 patch=36 Sep 6 17:58:45 eneco-001-209949 daemon.info chronyd[1299]: hz=100 shift_hz=7 freq_scale=1.00000000 nominal_tick=10000 slew_delta_tick=833 max_tick_bias=1000 shift_pll=2 Sep 6 17:58:45 eneco-001-209949 daemon.err chronyd[1299]: Could not open IPv6 NTP socket : Address family not supported by protocol Sep 6 17:58:45 eneco-001-209949 daemon.err chronyd[1299]: Could not open IPv6 command socket : Address family not supported by protocol Sep 6 17:58:45 eneco-001-209949 daemon.info chronyd[1299]: Frequency 6.556 +/- 1.712 ppm read from /var/lib/chrony/chrony.drift Sep 6 17:58:49 eneco-001-209949 daemon.warn chronyd[1299]: No intersecting endpoints found

by **TheHogNL** » Thu Sep 06, 2018 5:47 pm

You are not describing your issue :-)

only posting a good logfile

by **MyZ** » Thu Sep 06, 2018 5:48 pm

problem = topicname

To be more exact, it's 3 minutes behind

by **TheHogNL** » Thu Sep 06, 2018 6:20 pm

And did you also modify your chrony config as said earlier?

by **MyZ** » Thu Sep 06, 2018 6:33 pm

Not yet, first I went the "easy way" as you described:

Just restart chrony a few times and it will create the necessary files for it to sync properly

Will modify the file with the other time server.

by **MyZ** » Thu Sep 06, 2018 6:43 pm

Changed the server to:

In sync now!

by **TheHogNL** » Thu Sep 06, 2018 6:48 pm

That restart was necessary to fix the errors shown in the log (after the change to the pool.ntp.org servers)

by **MyZ** » Thu Sep 06, 2018 7:03 pm

Ah! It makes all sense now