Home Automation Domotica Forum Europe, Bwired Forum

I have an CTX35 RS232 com module.
It is working via Hyperterminal or the CTX35 test programm. It runs on 19k2 baud. RS232 Com port on my computer is OK. because of this result
Allthough it isn't communicating with the "XANURA SAOFTWARE 2"
Does anyboady have an idea? how to get this working.

thanks in advance
Wijnen

Xanura 2 software is intended to use with CIX computerinterface. Not with CTX35.

CTX35 cannot be used to program scenario's it is just an interface between X10 network and computer running software like Homeseer (for example).