Home Automation Domotica Forum Europe, Bwired Forum

I am considering to buy the Linksys WRT610N router and upgrade parts of my house LAN to 1GB.

What will happen if I have 2 computers on 100MB en 2 computers on 1GB connected to the internal switch?

Will the entire etwork switch back to 100MB -or-
Will the switch be able to support both??

Anybody experience with this?

Francois
________________________________________________________________________________________________________________________
Homeseer V2, RFXcom receiver, Harrisson Electric Curtains, Touchscreen + homebrew interface. DigiBee+, Velleman Relay board, homebrew optocoupler interface, homebrew Aritech interface, homebrew DigiBee-Homeseer interface.

The pc's with 100mbit will communicate on 100mbit and the pc's connected to gigabit will be able to communicate on 1gbit. It's not like wireless where the wireless netwerk will be switches back to the lowest speed connected clients.

--
Maarten Damen

www.maartendamen.com

If you have a transfer between the 100 MBit and 1 Gbit client, the transfer wil max 100 Mbit. So 10x 100 Mbit clients can use the full bandwidth of the 1 Gbit client.
If depends of the throughput of the backplane how much throughput you will have if more clients are initiating a transfer.

Just make sure you don't switch on 'jumbo frames' because they cannot be routed to 100Mb nodes. For the rest it will work fine because it's a switch, not a hub.

Thank you all, btw. Paradigit has a special offer on this router EURO 170 -/- 40 euro discount from LinkSys if you give them you old router.

Francois
________________________________________________________________________________________________________________________