Page 1 of 1
Harmony 1000 programming
Posted: Sat Oct 24, 2009 9:03 am
by DennisH
Hello,
Can someone tell me how to setup the Harmony 1000 to be used with Xanura?
I have a IRIX35 installed in the P-serie and i have already installed Xanura on the Harmony 1000.
Regards,
Dennis
Harmony 1000 programming
Posted: Sat Oct 24, 2009 9:42 pm
by TANE
What is the problem?
If all is installed just send the correct IR signal for triggering.
Example A1 on
<hr noshade size="1"><font size="1">Enver
http://twitter.com/Chak64%20My%20Domoti ... dware.html<i> My Domotica Hardware Software</i></font id="size1">
Harmony 1000 programming
Posted: Sat Oct 24, 2009 10:22 pm
by DennisH
That is the problem!
Where in the logitech software can i program this?
Regards
Dennis
Harmony 1000 programming
Posted: Sat Oct 24, 2009 10:38 pm
by TANE
Which remote did you selected for x10 control in the Harmony Software.
<hr noshade size="1"><font size="1">Enver
http://twitter.com/Chak64%20My%20Domoti ... dware.html<i> My Domotica Hardware Software</i></font id="size1">
Harmony 1000 programming
Posted: Sun Oct 25, 2009 3:29 pm
by DennisH
Which remote would you recommend tot program into the Harmony?
Regards,
Dennis
Harmony 1000 programming
Posted: Sun Oct 25, 2009 4:37 pm
by Bwired
this is going good
<hr noshade size="1"><font size="1">Pieter Knuvers
http://www.bwired.nl <i>Online House in the netherlands. Domotica, Home Automation.</i></font id="size1">
Harmony 1000 programming
Posted: Sun Oct 25, 2009 5:08 pm
by DennisH
I've had Eaton Xanura selected.
I now have tried several different options but i can't find the option that Light 1 is A1
Regards,
Dennis