Home Automation Domotica Forum Europe, Bwired Forum

i have added a few Virtual Devices in the RFXcom plugin,
now i am not sure i have the right setup.
it seems that the instand power use is a bit high ?
or is this correct is this a normal value.

do i have to give a (div) value for instant power use,.....i have 10000 counts a KWH

instant use gives about 5500 W is this a normal use,, (during day no lights on )

If 55 watts during the night would make sense i would add a divide-by-100

Posted with TouchBB on my iPhone

RTM chapter 9 http://www.rfxcom.com/documents/RFXCOM% ... 0Guide.pdf

Normally you will use the same settings for the suffix and the Divide By on the Virtual sensor as set for the corresponding Input Sensor.

the instant use is in W and the day use in Kwh.



this are the sfx standard giffen whan the virtual divices are added, or is it not possible to give W for instand use.

If for kWh a division of 10.000 is entered than use a division of 10 for Watts.

1 kWh = 1000 W so 10000/1000 = 10