X10 control of dimmable LED strips
Posted: Mon Mar 29, 2010 3:41 pm
Dear group,
I know this topic has been touched on before, but I haven't found any clear answer to this. I've just installed some dimmable LED strips, but these are 12v DC dimmers which sit "behind" the transfo... The dimmer itself is controlled by a potential-free switch (click once to turn on/off, hold for dim).
Is there any way to control this with a Marmitek/Xanura solution (I have all micromodules for other lighting). I know there are references to a mains-dimmable transfo in some other posts, but I think the allowed W is too low.
My dimmer also has an 0-10V analog interface....
Any thoughts and comments are very much appreciated,
best regards,
Nik.
I know this topic has been touched on before, but I haven't found any clear answer to this. I've just installed some dimmable LED strips, but these are 12v DC dimmers which sit "behind" the transfo... The dimmer itself is controlled by a potential-free switch (click once to turn on/off, hold for dim).
Is there any way to control this with a Marmitek/Xanura solution (I have all micromodules for other lighting). I know there are references to a mains-dimmable transfo in some other posts, but I think the allowed W is too low.
My dimmer also has an 0-10V analog interface....
Any thoughts and comments are very much appreciated,
best regards,
Nik.