Home Automation Domotica Forum Europe, Bwired Forum

Hi All,

i have a cm15 and a pmix35, when i use the cm15 i can reach al my x10 diveces, but when i chance to my pmix35 i can't reach all my divices.

is the cm15 stronger than the pmix15? and how can i make the signal of the pmix equal to the cm15

my configuration is homeseer an a x10 interface

gr marcel

Are they located at the same place in your setting

yes,
they are at the same place, i just swap them
it looks that the pmix35 has les power

i have done some testings an i have find out that the pmix is sending on 0 degrees instead of 120

i have tried to make a serial connection whit putty, but i can not make a connection

can someone tel me the right settings, and am i using the right programm?

thanks
marcel

i think i have the problem solved

made some settings in PMIX network analyzer software