Page 1 of 1
No open-zwave option under ZWave settings
Posted: Tue Apr 02, 2013 10:25 am
by birdhouse99
Hello,
Domotiga on Rpi.. Followed
http://domotiga.nl/projects/domotiga/wiki/Z-Wave .
Installed with no errors but can not enable open z wave.
Any idea what could be wrong ?
U
Re: No open-zwave option under ZWave settings
Posted: Tue Apr 02, 2013 12:31 pm
by wwolkers
What's the problem exactly?
There's a check box on the top right corner, which needs to be checked to enable Z-Wave support. Is that not working? Cause it's turned off at the moment.
Re: No open-zwave option under ZWave settings
Posted: Tue Apr 02, 2013 12:38 pm
by j.hoekstra
Did you install the wrapper? Then you should be able to enable it in the settings. The only supported version now is the open z-wave version, so no need to explicitly enable open z-wave.
Re: No open-zwave option under ZWave settings
Posted: Tue Apr 02, 2013 2:28 pm
by wwolkers
You DO need to enable it, or nothing will happen, wrapper or not.
What's in your logfile? If the wrapper is outdated, it won't stay enabled and give you an error in the log.