Home Automation Domotica Forum Europe, Bwired Forum

I just got an AN157 module and would like to make the association with the HomeSeer Z-Wave interface but there are not association options for the module. However the manual states

Programming
The On/Off button allows the user
- Turn on or off the load attached
- Include or exclude the Module from the Z-WaveTM system
- Control other Z-WaveTM enabled devices

Maybe the detection of the device capabilities is broken in HSPRO(2) ?

My experience with AN-157 is that you need to push the button 3 times. If I remember right the manual says 1 push.

I use them on HS2.

Regards
Morten