Page 1 of 1
Marmitek sensors ms13 doesn't connect to control unit SC9000
Posted: Sat Dec 28, 2013 12:17 pm
by Frankge973
I bought a second hand control alarm unit Sc9000 plus PIR four sensors, two ms13 and two ms90. Ms13 sensors doesn't register in control unit when I set it up using install area of menu. One ms90 is working perfectly, one is working but only in repetitive detection mode, even if I change the selector on the rear.
In your opinion, why they don't register ?
Thanks
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
Posted: Sat Dec 28, 2013 7:26 pm
by mbliek
The ms13 is not an supported motion sensor for the sc9000. Only the ms90
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
Posted: Sat Dec 28, 2013 8:52 pm
by Frankge973
And do you think is possible to use also sensors of other brands? Or I'm obliged only to use ms90?
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
Posted: Sat Dec 28, 2013 10:53 pm
by mbliek
The ms90 is also available from other brands. But it's the same.
But only the ms90 will work
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
Posted: Sun Dec 29, 2013 1:37 am
by Frankge973
And which cheaper brand and model can I buy?