Page 1 of 1
Using the gateway with Domoticz
Posted: Sun Jan 19, 2014 12:50 am
by pwhooftman
sappien wrote:I've got a problem with the setpoint setting. When I send a TT= to the gateway, the setpoint is correctly adjusted. But after 30/40 minutes the iSense restores the setpoint.
(iSense program is 07:00 21C - 21:00 15C) (using OTC+Eco mode setting)
14:00 i've send TT=15
14:40 Setpoint is set back to 19
Hi,
I see you managed to present values from the OpenTherm gateway in Domoticz. Can you give me pointers how to achieve that?
Thanks.
Re: Using the gateway with Domoticz
Posted: Tue Jan 21, 2014 1:12 pm
by sappien
pwhooftman wrote:Hi,
I see you managed to present values from the OpenTherm gateway in Domoticz. Can you give me pointers how to achieve that?
Thanks.
Domoticz has support for the OpenTherm gateway (only readings at this moment, altering the temp must be done with a little script)
Re: Using the gateway with Domoticz
Posted: Sun Jan 26, 2014 12:13 am
by terrarium
Domoticz has support for the OpenTherm gateway (only readings at this moment, altering the temp must be done with a little script)
My logfile shows:
OTGW connected to: 192.168.1.103:1001 (I have the OTGW wifi)
Otmonitor shows status of Boiler and I can see output in the log.
No devices show up in Domoticz however.
Running the latest Beta.
How long does it take for the devices to show?
How long does it take for the devices to show?
It takes some time apparently. .... It's up and running now.