Define address of Micro Modules
Posted: Tue Apr 29, 2014 11:10 am
Hi all,
Something I always struggle with, is the definition of the address of Micro modules, in this case a S3160M that has lost it's address because a power dip (but also applicable for other modules). What is the correct procedure?
The manual says: press the setup button for 5 seconds (so far so good) and then 'send the adress'. I use my CM15pro or remote control to send an 'ON' command, but module simply jumps out of setup mode after 30 seconds. I tried other commands, but no luck. In the past I succeeded in programming the modules (but it never seems to work at the first try), but now I don't arrive at all.
Regards,
Kristof.
Something I always struggle with, is the definition of the address of Micro modules, in this case a S3160M that has lost it's address because a power dip (but also applicable for other modules). What is the correct procedure?
The manual says: press the setup button for 5 seconds (so far so good) and then 'send the adress'. I use my CM15pro or remote control to send an 'ON' command, but module simply jumps out of setup mode after 30 seconds. I tried other commands, but no luck. In the past I succeeded in programming the modules (but it never seems to work at the first try), but now I don't arrive at all.
Regards,
Kristof.