Home Automation Domotica Forum Europe, Bwired Forum

Help I have a problem who knows the answer:
My X10/S10 modules are on one fase in three groups after residual current operated circuit-breaker.
Now the following problem happens sometimes when I sent a signal from the wall scene controller S4206 the signal does not reach the CM11 or the X10 module what is next to it.
I have took out the plug from everything what I thougt that was give a interference but nothing worked untill I took out the CM11 plug!!! and put it back then every thing workes fine for a little wile.
Till the samething happens again.
Is the CM11 broken????
Thanks for the replies. Paul


It was the combination of a S2026 plugin lamp module with a trafo attached on it, I replaced the module for a applaince module and the problem's are gone for more then a week.

Hi Paul,
I have heard a lot but not this, it's a strange problem. Have you tried plugging the CM11 in another place. I don't think the CM11 is defect. I had the best result in plugging the CM11 in the fusebox closet. This even worked for me over 3 phases, I could reach a lot of outlets this way.
Regards Pieter (thanx for translating [:)] )

Thanks for the reply, The CM11 is installed in the fuse box closed.
It is working now well for a few days, I hope it stays this way.
Regards Paul.
EDIT it is still not OK, it happened again put out the power supply of the CM11 and after that it worked again fine!!!
Is the CM11 broken? will the CTX35 worke better?
And at last is the sent signal strenght of the CTX35 stronger then the CM11?

Thanks for the answers

<blockquote id="quote"><font size="1" face="Verdana, Arial, Helvetica" id="quote">quote:<hr height="1" noshade id="quote"><i>Originally posted by Paul H te O</i>
<br />Thanks for the reply, The CM11 is installed in the fuse box closed.
It is working now well for a few days, I hope it stays this way.
Regards Paul.
EDIT it is still not OK, it happened again put out the power supply of the CM11 and after that it worked again fine!!!
Is the CM11 broken? will the CTX35 worke better?
And at last is the sent signal strenght of the CTX35 stronger then the CM11?

Thanks for the answers
<hr height="1" noshade id="quote"></font id="quote"></blockquote id="quote">i have the same problem with my tm13 (sometimes my kitchen is going on and off for a couple of minutes). if i plug it out and in againe is the problem solved for some ouhres or days.

Weird... o_O