I bought a second hand control alarm unit Sc9000 plus PIR four sensors, two ms13 and two ms90. Ms13 sensors doesn't register in control unit when I set it up using install area of menu. One ms90 is working perfectly, one is working but only in repetitive detection mode, even if I change the selector on the rear.
In your opinion, why they don't register ?
Thanks
Marmitek sensors ms13 doesn't connect to control unit SC9000
-
- Starting Member
- Posts: 5
- Joined: Sat Dec 28, 2013 12:09 pm
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
The ms13 is not an supported motion sensor for the sc9000. Only the ms90
-
- Starting Member
- Posts: 5
- Joined: Sat Dec 28, 2013 12:09 pm
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
And do you think is possible to use also sensors of other brands? Or I'm obliged only to use ms90?
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
The ms90 is also available from other brands. But it's the same.
But only the ms90 will work
But only the ms90 will work
-
- Starting Member
- Posts: 5
- Joined: Sat Dec 28, 2013 12:09 pm
Re: Marmitek sensors ms13 doesn't connect to control unit SC9000
And which cheaper brand and model can I buy?