Hi guys.
Planing to connect arduino or esp8266 to RS232 on my powermax complete.
To do this I need a good access to internals of the alarm. Opening a front panel is not a problem (get a warning light).
But when I remove the ribbon cable from the front panel to back panel - outside siren goes off.
Q: What is the best way to disable the alarm for the duration of tinkering (I have access to installer menu, but nothing obvious).
Cheers,
Irek
PowerMax Complete: hot to shut down for opening?
Moderators: Rene, Willem4ever
Re: PowerMax Complete: hot to shut down for opening?
If entering installer mode does not prevent the alarm, can't you just temporarily remove the siren from the config?
(backup current config first)
(backup current config first)
Re: PowerMax Complete: hot to shut down for opening?
Cheers, good advice.