Home Automation Domotica Forum Europe, Bwired Forum

Ok. I get the JSON information from OTG with the following LUA code: local IP = "xxx.xxx.xxx.xx" local Port = "8080" OpenTherm = Net.FHttp(IP,Port) response = OpenTherm:GET("/json") fibaro:debug(response) The response is: { "otgw": { "time": "20...

Great. Thanks for the info.

Ik heb nog een Vera 3 controller te koop.
Ik heb hem ongeveer 5 weken in gebruik gehad omdat ik uiteindelijk toch naar Fibaro HC2 ben overgestapt.

I use the OTG with the OT Monitor program running on a Raspberry.

Is it possible to get the current values (e.g. room temperature) and to send commands (e.g. room temparature up 1 degree) by (http) commands from an other application?
Does the OTG support an API?

Regards, Jeroen.

Dag Onno,

hoe oud is hij?

Gr, Jeroen.

I got it up and running again!

It appeared thet ser2net was not installed. I really do not understand why since I restored a working image on the TP Link.

Has anyone got OTG running in combipnation with fibaro HC2? I can remember a post saying that it is possible to run OT monitor on a Raspberry Pi with the OTG connected and then create a virtual device on HC2. I can't find that post anymore. Any suggestions how to control my CV with OTG throught HC2?...

Still no luck... I can contact the tp link. I restored the original firmware on it (I made a backup of the tp link when i just got it). I configured it to my situation (ip adress). A month ago this setup worked fine (connected to port 1001). Now it doesn't. The netstat -an command revealed that noth...

Thanks for the suggestions.
I will try them today.

Until recently my OpenTherm Gateway was working fine. It was connected by USB and a TP-LINK 710N. I controlled the gateway through my Vera 3 system. Now I can not connect to the gateway with the OTMonitor application (IPadress:1001). I get a 'connection refused' error. I haven't made any changes on ...

Hi, could you also send me the image and manual?
I have a TP link: TL-WR710N

Thx.