Duwi Z-Wave Impulsdrukker

Post by **beatboxer05** » Wed Nov 11, 2009 12:10 pm

Hello everyone,

I am thinking about buying the Duwi Z-Wave Z-Wave Impulsdrukker INTERACT. But I am wondering if this "impulsdrukker" can communicate with the Aeon Lab Z-stick ? So that I can add the "impulsdrukker" to my z-wave network with Z-tool from homeseer. Does anyone know if this is possible ?

Kind regards,

Niek

Post by **TANE** » Wed Nov 11, 2009 12:54 pm

This device will communicate with Aeon labs.
You will see some information in Homeseer but no status changes or event trigger option.

<hr noshade size="1"><font size="1">Enver
Twitter http://twitter.com/Chak64%20My%20Domoti ... tane.nl/wp</font id="size1">

Post by **beatboxer05** » Wed Nov 11, 2009 1:13 pm

Hello Tane,
Thank for your reaction,

At the moment I am making my own small Z-wave program. The question I asked in the beginning of this topic, I asked because I want to know if the duwi remote switch sends a signal to the Aeon Lab z-stick when you push on it. I can see the possibly sended signal via a com port monitor programm. But to do this I had to know if the Aeon lab Z-stick and the Duwi impulsdrukker work together via Z-tool.

Do you have to put the duwi impulsdrukker in some special mode before you can communicate with him ? Like the merten impulsdrukker,which has to be pushed three times to set him in program mode

kind regards,

Niek

Post by **TANE** » Wed Nov 11, 2009 1:17 pm

This part in English.
please translate.

It will be a challenge to write your own application
I'm not sure if there is any status update info is send...Else will Homeseer and VERA also use this info.

<hr noshade size="1"><font size="1">Enver
Twitter http://twitter.com/Chak64%20My%20Domoti ... tane.nl/wp</font id="size1">