Te koop DigiBUTLER Ethernet WEB-controller (Elektor)

Post by **Grab485** » Fri Jun 05, 2009 8:25 am

I will to sell DigiBUTLER Ethernet WEB-controller (Elektor)for 100 Euro

and programmer TBLCF for 50 Euro

All hardware is soldered and tested. In full working condition.
The DigiButler has DHCP enabled, thus will work in any Ethernet network.

http://www.elektor.com/magazines/2008/a ... 9032.lynkx

Post by **Lempens** » Fri Jun 05, 2009 9:49 am

whats the different with the version that Elektor sells for 37.70
other then it's being soldered and tested.

http://www.elektor.com/products/kits-mo ... 1183.lynkx

Post by **Grab485** » Fri Jun 05, 2009 10:08 am

The difference is: it has different (latest) firmware with DHCP enabled.
You can not buy it. You have to compile and burn it by yourself. Of course, sources and manuals are available.
It took 1 week for me. I am an experienced embedded electronics engineer. For normal people it is nearly impossible. Because before one should buy or make a programmer. And story begins again.

Otherwise you will stuck with pre-programmed IP address in a subnet 192.168.0.XXX with no chance if your network is for example 192.168.1.XXX. Moreover, the old firmware has a bug, when it does not connect to Ethernet with some hubs.

So the difference is as between died and alive body: the soul

Post by **RDNZL** » Fri Jun 05, 2009 1:13 pm

I have a digibutler in a box still to be build, thought about selling it, but I have waited for months (half year maybe?) to get it delivered because of PCB design/build errors, so I'm kinda attached to it

No idea what to build/realize with it though, any ideas anyone?

Regards,
Ron

Post by **Grab485** » Fri Jun 05, 2009 1:23 pm

<blockquote id="quote">quote:<hr height="1" noshade id="quote">Originally posted by RDNZL
 I have a digibutler in a box still to be build, thought about selling it, but I have waited for months (half year maybe?) to get it delivered because of PCB design/build errors, so I'm kinda attached to it

No idea what to build/realize with it though, any ideas anyone?

Regards,
Ron
<hr height="1" noshade id="quote"></blockquote id="quote">

For the first, try to use it as a remote (thousands miles) control for your kitchen light. It was designed exactly for this.

Post by **timf1** » Fri Oct 30, 2009 9:01 pm

hi Grab,

If you alwayse have a Digibutler and/or a TBLCF for sold, give me a signed!

Post by **Grab485** » Sat Oct 31, 2009 9:16 pm

<blockquote id="quote">quote:<hr height="1" noshade id="quote">Originally posted by timf1
 hi Grab,

If you alwayse have a Digibutler and/or a TBLCF for sold, give me a signed!

<hr height="1" noshade id="quote"></blockquote id="quote">

Yes, I am still alive [:)] and I have one Digibutler and one TBLCF for sell.