Getting my Harrison curtain to work

[Alexander]

the reverse option should be a option within HS for all devices.

[abl]

I've just installed the Harrison Neta 12 rail and it works fine with the remote control. However I don't have an idea how I have to configure this to be able to control via Homeseer. There is a reference to documents but unfortunately they don't work anymore. Anybody that can help me out?

What I did so far:

- installed the curtain
- opened the remote control to find dip switches
- run rfxmitter and put the dip switches under the harrison tab; this works
- went to webinterface of rfxcom under homeseer and added output devices ('curtain')

Not sure how to proceed....

[Post-IT]

Found the old documentation on the forum:
http://www.domoticaforum.eu/uploaded/b_ ... itions.pdf

But the information has not vanished, it is merged in to the new documentation Chapter 7.2:
http://www.rfxcom.com/documents/RFXtrx% ... 0Guide.pdf

Or some forum entries I found using search:
http://www.domoticaforum.eu/viewtopic.p ... 64&start=0
http://www.domoticaforum.eu/viewtopic.p ... 96&start=0

[abl]

Thanks Post-IT, you pointed me in the right direction. I've got one curtain now controlled via Homeseer! Two to go (first waiting for some proper power-transformators)...

[abl]

Any solution on the reversal of the open/close? Just noted that a press on the open button causes the curtains to close and vice versa...

[Post-IT]

I just switched the wires on the single rail which had to go reverse. Only problem is the stickers on the remote are then reversed.

I'm not sure if the plugin now has the option to do reverse commands, I don't use HS anymore.