i have added a few Virtual Devices in the RFXcom plugin,
now i am not sure i have the right setup.
it seems that the instand power use is a bit high ?
or is this correct is this a normal value.
do i have to give a (div) value for instant power use,.....i have 10000 counts a KWH
instant use gives about 5500 W is this a normal use,, (during day no lights on )
Virtual Devices setup
Moderator: b_weijenberg
If 55 watts during the night would make sense i would add a divide-by-100
Posted with TouchBB on my iPhone
Posted with TouchBB on my iPhone
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Re: Virtual Devices setup
RTM chapter 9 http://www.rfxcom.com/documents/RFXCOM% ... 0Guide.pdf
Normally you will use the same settings for the suffix and the Divide By on the Virtual sensor as set for the corresponding Input Sensor.
Normally you will use the same settings for the suffix and the Divide By on the Virtual sensor as set for the corresponding Input Sensor.
Re: Virtual Devices setup
the instant use is in W and the day use in Kwh.
this are the sfx standard giffen whan the virtual divices are added, or is it not possible to give W for instand use.
this are the sfx standard giffen whan the virtual divices are added, or is it not possible to give W for instand use.
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Re: Virtual Devices setup
If for kWh a division of 10.000 is entered than use a division of 10 for Watts.
1 kWh = 1000 W so 10000/1000 = 10
1 kWh = 1000 W so 10000/1000 = 10