Configuring scenes with Everspring SM103 contactsensors

[edek]

I'm trying to configure scenes with 2 Eversrping SM103 contactsensors. What I'm trying to accomplish: 2 doors, one in front of the garage, one in the back, each equipped with one SM103. When I open the front or back door, a scene (nr1) is triggered to switch on the light and leave it on for an hour. When I close one of these doors, another scene (nr2) is triggered to swithc the light off (with a delay of 5 minutes). I'm trying to find a way that both doors must be shut before scene nr2 switches the lights off, this way if I'm busy in the garage I can leave one of the doors open, and the lights will stay on for an hour (should be long enough). I can't find out if this is possible, or how to accomplish this. When I shut one of the doors the switch off scene is triggered.
Any ideas?

[TANE]

Are you using homeseer.

[edek]

Ah, sorry, i'm using Vera UI 3.

[TANE]

My Vera is just for testing. I don't have any event running on the Vera.
In Homeseer this can be done with delayed events.

[edek]

Ok, I switched over to Homeseer (trial version), this is more flexible then Vera. Got everything up and running, I'll probably buy a license this week.
Thanks!