Program SAX1, SAIX using CM11

Post by **wegdom** » Sun Feb 17, 2008 12:37 am

I am trying to program a new address into a SAX1 and SAIX using Homeseer and a CM11. Tried all kinds of variations like:

Sub Main
hs.execx10 "D2",0,0,0
hs.waitsecs 3
hs.execx10 "D2",0,0,0
End Sub

Is it possible to do this and if so, what would be the correct script for that? Because the above obviously does not work.

Greetz,

Wil

Post by **TANE** » Sun Feb 17, 2008 12:46 am

I think 3 sec wait is to long...this my script

Sub Main
hs.ExecX10 "k7","on", 0, 0
hs.ExecX10 "k7","on", 0, 0
hs.ExecX10 "k7","hail ack", 0, 0
hs.ExecX10 "k7","hail ack", 0, 0
End Sub

Post by **wegdom** » Sun Feb 17, 2008 8:54 am

I have tried that script (on the SAIX) and that does not work either.
Now I wonder, can I use a CM11A interface for this? The manual says I must use a PUX or CIX. Well, the CM11A is a computer interface...[:I]

Post by **TANE** » Sun Feb 17, 2008 3:17 pm

I have the CIX.
CM11 is also sending X10..never test it.

Post by **Bwired** » Mon Feb 18, 2008 9:14 pm

CIX? I think you mean CTX35?

Post by **TANE** » Mon Feb 18, 2008 10:38 pm

yep..the CTX35
and for my backup domotica CIX

Post by **wegdom** » Wed Feb 20, 2008 12:35 am

I have solved this issue. For some weird reason Homeseer/CM11A allows me to program an AIX switch but not the SAX1 and SAIX. But, since a programmed AIX switch sends the "address" (+1, +2, +3) plus "on" command when activated I am able to use the AIX switch to program the SAX1 and SAIX.

You do not want to use this work around all the time, but it does the trick; finally. [8D]