Homepro controller

Forum and Topics about Z-Wave devices.
Post Reply
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

Homepro controller

Post by Wim2008 »

In my home I have some Merten duall wall controllers, but I saw on internet that the Homepro dual wall controller is a little bit cheaper then the Merten.
In my domotica system I use Aeon stick as secondairy controller. The Merten stick is primarily.
Will both switches of the Homepro dual wall controller work in my configuration?
Has someone some experience with the HomePro dual wall controller.

B.R. Wim :) :wink:
User avatar
TANE
Forum Moderator
Forum Moderator
Posts: 4806
Joined: Fri Apr 06, 2007 9:46 pm
Location: Netherlands
Contact:

Re: Homepro controller

Post by TANE »

Homepro controller will work fine in with merten and Aeon.
Homepro stopped the production and is developing new products. You can only but from old stock

Quality of the merten products is 100% more solid than Homepro.
Last point all the Homepro wall controllers are power line powered..merten is battery powered.
Enver Tanriverdi | http://blog.tane.nl
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

Re: Homepro controller

Post by Wim2008 »

Enver, thanks for your info.Both switches will work fine in HS if the aeon stick is secondary?
What does it means 'by old stock'. Can't I buy those switches in a few months?

B.R. Wim :) :wink:
User avatar
TANE
Forum Moderator
Forum Moderator
Posts: 4806
Joined: Fri Apr 06, 2007 9:46 pm
Location: Netherlands
Contact:

Re: Homepro controller

Post by TANE »

Most of the ACT products are EOL
no info available about the new ones.
If you are using Merten my suggestion is go for Merten...it will cost you 15 euro more .. quality is much better.
Enver Tanriverdi | http://blog.tane.nl
Wim2008
Advanced Member
Advanced Member
Posts: 718
Joined: Wed Aug 12, 2009 1:42 pm
Location: Eindhoven, Netherlands

Re: Homepro controller

Post by Wim2008 »

Thanks.
Post Reply

Return to “Z-Wave Forum”