more motion sensors in same house code

[Harry]

i added a few motion sensors to the system.

the sensors seems to be recieved correct by the rfxcom reciever.

but i have a problem , the reciever seems to produce a M on.
i expect an M20 on,..?
i set it up in the configuration this way, is this correct?


the problem is that i set up an event for lets say motion sensor m11, the event is trigered from another motionsensor.
m20 or the m26 sensor....
or is it not possible to have more then one motion sensors in a house code??

[b_weijenberg]

the pictures are not readable.

please contact support and attach the pictures.

[Harry]

an status update of this problem i had,
i used an offset of 10 for the unitcode's, looks like this hi unitcode range will not good handeld whitin homeseer.
after loosing the offset ,and using house code's from 1 and up, all works fine.
so problem solved, thanks to support (very fast respons by the way) great .....and thanks again.