RFXtrx RFXman and KaKu doorbell

[WinuX]

How can I receive of transmit a signal to a Kaku doorbell with a learn button, inside RFXman.
I can't find the automatic code for the doorbell.

Thnx!

[b_weijenberg]

In RFXmngr:
Select Type = AC on the Lighting2 tab
Select a random ID number <> zero
push the learn button on the KAKU doorbell,
Transmit an On command.

The KAKU is now paired with the ID/Unit selected.

If pairing is not possible, reset the KAKU and retry

[WinuX]

Thnx you very much!

It works. Can I do every KaKu device with the learn button, this way?
I will need to change the id for another device?

[b_weijenberg]

The selection is made by the ID and the Unit number.
So you can select up to 16 units using the same ID.

The ID can have a number from 1 to 67.108.863
You can install a total off 67.108.863 * 16 = 1.073.741.808 KAKU's

[WinuX]

While te code be saved in the KaKu device or in the RFXmnr / domotica software?

[b_weijenberg]

For a KAKU transmitter (remote/wall switch/doorbell button)
The KAKU address code must be saved in the domotica application so that action can be triggered on a command (on/off) received from this KAKU transmitter.

For a KAKU receiver (lamp module/chime) :
The address code is saved in the KAKU and to control the domotica application has to use this address code to control this KAKU.

[WinuX]

I understand, thanks for the explanation.

[bigalf]

Which KaKu doorbell do you have ? I have problems with the ACDB-6500AC and the motion sensor AWST-6000. I have seen the doorbell a few times within HomeSeer/Rfxmngr, and the motion sensor never ?