Change house-code Xanura SAIX12

[DJF3]

Hi,

Just wanted to re-program my Xanura SAIX12 (which is now working fine) to a different House/Device code.
(homeseer 2.5.x, Xanura CTX35)

- Keep program button pressed 3 seconds
- LED is ON
- &hs.ExecX10 "E4","ON"
- wait 5 seconds
- &hs.ExecX10 "E4","ON"

But the module doesn't seem to receive the new house/device code? The HS Log indicates that everything works fine and the X10 command is send.
Sending &hs.ExecX10 "A1","ON" works fine. I've had this issue when installing the module years ago. Can't remember what the trick was.

Any ideas?
DJ

[Bwired]

I use a rf remote for this, try to decrease the seconds between transmitting

[DJF3]

<grin>
That was the plan when I realized that I got rid of my TM13's So the only way to get an X10 signal onto the powerline is throught the CTX35 --> Only through Homeseer ;-(
Will try sending the signal faster.
Is there a way to control the CTX35 directly through software (instead of via Homeseer?)

DJ

[Peterpc]

You can use the CTX35 test software.

[DJF3]

That's a great tip.. Will try the CTX35 test software

Cheers
DJ