HomeEasy and RF Transmitter

[laserchris]

Hi there, can someone explain how the addressing works within the RF Transmitter app for homeeasy devices?

I have version 10 tranmitter so should be able to control both types of homeeasy devices but cant work out what address I should provide in the RF Transmitter software under the homeeasy tab.

thanks
Chris

[b_weijenberg]

Chris,

You can enter any address and put the HE module in programming mode. Enter an On cmd and the HE module will respond to On and Off cmds from RFtransmitter using that address. This is for testing purposes only.

For operational use you can create an AC output device in the Homeseer RFXCOM plug-in. Set the HE module in programming mode and enter in Homeseer an On cmd for that device.

It can be necessary to reset the HE module to erase all programmed remotes. Push and hold the program button on the HE module and when the LED start blinking fast (after about 10 seconds) release the button and press the button again shortly.

Bert

[laserchris]

thanks again Bert .. works a treat. All I need is 64bit support and I have everything I need.

Thanks again
Chris