Geheugen Xanura modules
Geheugen Xanura modules
Ik heb recentelijk een Xanura installatie aangeschaft, bestaande uit een HCB, RF interface incl. afstandsbediening en enkele modules van het type AIX, SAIX en DAIX10. Ik heb enkele modules genstalleerd om de werking van het systeem te testen. Dit gaat op zich goed. Nu wil ik echter het systeem definitief inrichten en kom ik erachter dat veel modules hun initile instellingen niet laten overschrijven. Met andere woorden, als ik via de HCB een AIX het adres A14 wil geven lijkt het hele proces goed te gaan totdat ik de lichtschakelaar bedien waarna de module eenvoudigweg de oude instellingen nog gebruikt op het oude adres. Het lijkt net alsof het geheugen niet overschrijfbaar is. Heeft iemand van jullie een soortgelijke ervaring/weet iemand hoe dit te verhelpen is??
Geheugen Xanura modules
Aub in het Engels vertalen! Forum is voornamelijk engelstalig
Dank
Dank
Geheugen Xanura modules
Are you sure you put the module in programming mode ...... by pushing the little plastic tab for more than three seconds so the led in the module is on steady. Be sure you will start programming within the 60 sec. window otherwise the module will get out of the programming mode.
Please check always by sending the right adress (twice) or command if the led will blink the right number of times as feedback.
Also be aware of programming the AIX with a starting adress of A14 it will generate and will use the following adresses A15,A16 and A1 .
It should work based on my experiences with many Xanura modules I'm using most of the times a remote control (ABX3) to send the required adresses and not the HCB.
Henk
Please check always by sending the right adress (twice) or command if the led will blink the right number of times as feedback.
Also be aware of programming the AIX with a starting adress of A14 it will generate and will use the following adresses A15,A16 and A1 .
It should work based on my experiences with many Xanura modules I'm using most of the times a remote control (ABX3) to send the required adresses and not the HCB.
Henk
Geheugen Xanura modules
Hi Henk,
I am sure the modules were in programming mode when programming through the HCB. The HCB also confirmes the succesfull programming in the log. But when using the switch after that I can see in the log that the old addres is beeing sent. Regarding the multiple adresses: if I don't check the alternative adresses, I thought they weren't reserved. Am I wrong here?
I also wonder if there is some code book available for the messages from the log. Sometimes I don't have a clue where errors seem to come from......
I am sure the modules were in programming mode when programming through the HCB. The HCB also confirmes the succesfull programming in the log. But when using the switch after that I can see in the log that the old addres is beeing sent. Regarding the multiple adresses: if I don't check the alternative adresses, I thought they weren't reserved. Am I wrong here?
I also wonder if there is some code book available for the messages from the log. Sometimes I don't have a clue where errors seem to come from......