motor blind control and procents dimlevel not working

[sjnelle]

I have a zwave.me motor blind control. I want to control it with dimlevel procents so when I set 50% the blind goes 50% down or up.
But when I send the values the heigt of blind is always different, mostly after I use full close or open.
I tried different software, domotiga,homegenie, homeseer.
I played with the full open and close parameters but I did not get It good.

I think I have to configure it from a good starting point but I don't know how and its driving me crazy.

Does anyone have some tips for me?

[uAlex73]

Did you try to calibrate it? This seems to be needed for roller blinds (other similar Fibaro device manual states that):
http://www.indome.ee/wp-content/uploads ... 10-ENG.pdf

I myself just ignore the percentage/dim, i am only interested in open or close.

[sjnelle]

there is nothing in the manual of the duwi for calibrating only the full open en close time paramters

[xanhoera]

For the original duwi devices managing the operating times was possible: http://www.ihomeautomate.eu/2011/10/22/ ... nd-insert/

[jrkalf]

Sorry to perhaps state the obvious, but perhaps you've already taken this into account.

When you're using blinds for sunscreens etc keep in mind that the roll-down is faster then the Roll-up phase. (at least, it' is in my case). So when working with percentages to manage an analog motor, you'l probably end up on different levels then you're expecting it would be.