Home Automation Domotica Forum Europe, Bwired Forum

Hi,

I'm in the middle of implementing my Xanura setup.
When i was analyzing my network with the PMIX35 i realized that i don't have any reference values to compare to.

I'd like to propose that we all post some values here so we might be able to extract some kind of acceptable values from the results. Before you start flaming me, i did read the PMIX35 manual and i could not find any reference levels in there. The manual only states that impedance my not be lower then 1.9ohm.

What noise and impedance levels do my colleague forum readers have ?

Cheers,
Peter

no flames here, but ... do you experience any issues then allready? if not, then there is no need right?

// Erik (binkey.nl)

I agree that it would still be nice to have a frame of reference here. So if I don't forget it, I will post some of my values here.

Hi,

No problems here, only finished the first floor of my home just now.
Just curious about other people's values.

Here are my levels:
Impedance = between 7.5 ohms and 12 ohms
Noise = between 0.07 volt and 0.30 volt


Cheers,
Peter

Impedance: 8.1 ohm (always it seems)
noise: 0,06 <-> 0,10 volt


// Erik (binkey.nl)

Impedance: ~5.5Ohm
noise: <0,05Volt

Impedance: 8,6 - 9,2 ohm
noise: 0,05 - 0,09 volt

Impedance: 1,3 Ohm
Noise: 0.03 Volt