How to program a RFIX35 with a letter code

Post by **tsiis** » Sat Nov 21, 2009 11:02 pm

I am trying to program my RFIX35 with the letter Code A. My XanuraHome dealer told me i can program the RFIX35 via the A10-Status page of my HCB. But i can't find a option to send the setup commands on that page.

Can anyone give me some advise how to program RFIX35 or how to send setup commands via the HCB ?

Post by **Bwired** » Sat Nov 21, 2009 11:38 pm

Read the manual, the best way to it is with a Xanura remote control.
I Don't know how to do it with the HCB, perhaps member Henk can tell.

<hr noshade size="1"><font size="1">Pieter Knuvers
http://www.bwired.nl <i>Online House in the netherlands. Domotica, Home Automation.</i></font id="size1">

Post by **tsiis** » Sat Nov 21, 2009 11:50 pm

i read the manual, but in then manual there isn't a word written about how to program the RFIX35 by the HCB. It is mentioned in the manual that you can program the RFIX35 with het HCB, but how to do that is not noted. Some help would be fine