i have 2 recievers , from one the input devices seen and configured in the rfxcom config screen are not seen in the main homeseer screens with their input sensor values
does anyone knows where the problem is ?
mvg,
labium
input devices not shown in device or state screen
Moderator: b_weijenberg
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Re: input devices not shown in device or state screen
There is no difference in processing of data received by any of the 8 configured receivers so I don't see the problem.
Contact support if you need assistance.
Contact support if you need assistance.
Re: input devices not shown in device or state screen
there is and was no problem i only thougt i had to add the domotica action transmitter devices to the input devices just like the oregon and visonic transmitters.
the user manual doesn't mention that. costs a few hours useless seeking.
wetlips
the user manual doesn't mention that. costs a few hours useless seeking.
wetlips
- b_weijenberg
- Forum Moderator
- Posts: 1744
- Joined: Sun May 14, 2006 4:32 pm
- Location: Netherlands
Re: input devices not shown in device or state screen
I suppose you mean X10 sensors with "domotica action transmitter devices"
For the full story see also: http://board.homeseer.com/showthread.php?t=147183
X10 sensors and X10 remotes are always directly configured in Homeseer, doesn't matter from which source, RF or Powerline.
For the full story see also: http://board.homeseer.com/showthread.php?t=147183
X10 sensors and X10 remotes are always directly configured in Homeseer, doesn't matter from which source, RF or Powerline.