X10 / RF Problem

[Antoon]

Hi,

I have a strange problem now for a couple of months and i can't find it.

I have a three phase installation with SFX40's filters and a FKX coupler.
I run Homeseer with only Xanura stuff and RFXCOM LAN 433 and 868 receivers.
In my house i have about 16 motion sensors (MS13 and BSX1)
And that is where my problem is.

Everything is working fine and HS is missing nothing without the MS13 and BSX1 motion sensors.
When i enable the X10 addresses in the RFXCOM plugin where i have my MS13 on then there is no problem at all.
But when i program the MS13 on the address then it seems that my X10 is picking up noise or something like that because then homeseer missed a lot of commands and my events don't run OK.

I have try to programm the MS13's on another adress,Put all new batteries in it enz.
Hope someone can help me because i am runing out of ideas.

Regards,
Antoon